Bryant Series E/F 310AAV User Manual download pdf (Page 4)

A10269

Fig. 2 --- Clearances to Combustibles

80 / 27 C

/ 16 C

A06745

Fig. 3 --- Return Air Temperature

INTRODUCTION

Series 140/E 4--way multipoise Category I fan--assisted furnace is

CSA design--certified. A Category I fan--assisted furnace is an

appliance equipped with an integral mechanical means to either

draw or force products of combustion through the combustion

chamber and/or heat exchanger. The furnace is factory--shipped

for use with natural gas. This furnace is not approved for

installation in mobile homes, recreational vehicles, or outdoors.

This furnace is designed for minimum continuous return--air

temperature of 60_F(16_C) db or intermittent operation down to

55_F(13_C) db such as when used with a night setback

thermostat. Return--air temperature must not exceed 80_F(27_C)

db. Failure to follow these return--air temperature limits may

affect reliability of heat exchangers, motors, and controls. (See

Fig. 3.)

For accessory installation details, refer to the applicable

instruction literature.

NOTE: Remove all shipping brackets and materials before

operating the furnace.

CODES AND STANDARDS

Follow all national and local codes and standards in addition

to these instructions. The installation must comply with

regulations of the serving gas supplier, local building, heating,

plumbing, and other codes. In absence of local codes, the

installation must comply with the national codes listed below and

all authorities having jurisdiction. In the United States , follow all

codes and standards for the following:

Step 1 —Safety

310AAV

1 2 3 4 5 6 7 8 9 ... 51 52

No comments

Bryant Series E/F 310AAV User Manual Page 4