Bryant DuraPac Series 580f User Manual download pdf (Page 15)

—15—

B. Optional EconoMi$er+

See Fig. 16 for EconoMi$er+ component locations.

NOTE: These instructions are for the factory-installed

optional EconoMi$er+ only. Refer to the accessory

EconoMi$er+ installation instructions when field installing

an EconoMi$er+ accessory.

1. To remove the existing unit filter access panel, raise

the panel and swing the bottom outward. The panel is

now disengaged from the track and can be removed.

See Fig. 17.

2. The box with the EconoMi$er+ hood components is

shipped in the compartment behind the

EconoMi$er+. The EconoMi$er+ does not have to be

removed to retrieve the hood box. Remove the screw

holding the hood box bracket to the top of the

EconoMi$er+. Slide the hood box out of the unit. See

Fig. 18.

IMPORTANT: If a power exhaust accessory will be installed

on the unit, the hood shipped with the unit will not be used

and must be discarded. Save the aluminum filter for use in

the power exhaust.

3. The indoor coil access panel will be used as the top of

the hood. Remove the screws along the bottom of the

indoor coil access panel. See Fig. 19.

4. Swing out the indoor coil access panel and insert the

hood sides under the panel (hood top). Use the screws

provided to attach the hood sides to the hood top. Use

the screws provided to attach the hood sides to the

unit. See Fig. 20.

5. Remove the shipping tape holding the EconoMi$er+

barometric relief damper in place.

6. Insert the hood divider between the hood sides. See

Fig. 20. Secure hood divider with 2 screws on each

hood side. The hood divider is also used as the bottom

filter rack for the aluminum filter.

7. Open the filter clips which are located underneath

the hood top. Insert the aluminum filter into the bot-

tom filter rack (hood divider). Push the filter into po-

sition past the open filter clips. Close the filter clips

to lock the filter into place. See Fig. 21.

8. Caulk the ends of the joint between the unit top panel

and the hood top. See Fig. 19.

9. Replace the filter access panel.

10. Install all EconoMi$er+ accessories. EconoMi$er+

wiring is shown in Fig. 22.

Barometric flow capacity is shown in Fig. 23. Outdoor air

leakage is shown in Fig. 24. Return air pressure drop is

shown in Fig. 25.

FILTER ACCESS PANEL

OUTDOOR-AIR OPENING AND

INDOOR COIL ACCESS PANEL

COMPRESSOR

ACCESS PANEL

HOOD BOX

BRACKET

Fig. 17 — Typical Access Panel Locations

Fig. 18 — Hood Box Removal

Fig. 19 — Indoor Coil Access Panel Relocation

SIDE

PANEL

INDOOR

COIL

ACCESS

PANEL

INDOOR

COIL

ACCESS

PANEL

CAULK

HERE

TOP

SIDE

PANEL

Fig. 16 — EconoMi$er+ Component Locations

ECONOMI$ER+

PLUG

ECONOMI$ER+

CONTROLLER

(UNDER COVER)

OUTDOOR

AIR HOOD

HOOD

SHIPPING

BRACKET

ECONOMI$ER+

CONTROLLER

LABELS

GEAR

DRIVEN

DAMPER

OUTDOOR AIR

TEMPERATURE

SENSOR

BAROMETRIC

RELIEF

DAMPER

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Comments to this Manuals

No comments

Bryant DuraPac Series 580f User Manual Page 15

Comments to this Manuals

Related products and manuals for Radiators Bryant DuraPac Series 580f