Bryant SYSTXBBECW01 Instruction Manual download pdf (Page 17)

4.3. Location

ELECTRICAL OPERATION HAZARD

Failure to follow this warning could result in personal injury

or death.

Disconnect power before routing control wiring.

WARNING

All wiring must comply with national, local, and state codes.

4.3.1. Wall Control

The Evolution Connex Control is the command center for the Evolution System. It

should be located where it is easily accessible and visible to the adult homeowner

or end user. For accurate temperature measurement, the following guidelines should

be followed:

The Evolution Connex Control and Remote Room Sensors SHOULD be mounted:

S Approximately 5--ft (1.5 m) from the floor.

S Close to or in a frequently used room, preferably on an inside partitioning wall.

S On a section of wall without pipes or ductwork.

The Evolution Connex Control and Remote Room Sensors SHOULD NOT be

mounted:

S Close to a window, on an outside wall, or next to a door leading to the outside.

S Exposed to direct light or heat from a lamp, sun, fireplace, or other

temperature--radiating objects which could cause a false reading.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 99 100

No comments

Bryant SYSTXBBECW01 Instruction Manual Page 17