Bryant SYSTXBBECW01 Instruction Manual download pdf (Page 23)

4.4.2. Damper Control Module (zoning systems only)

All zoning wiring is run back to the Damper Control Module. Select a location near

the furnace or fan coil where wiring from the control, each Remote Room Sensor or

Smart Sensor, each damper actuator, and the equipment itself can come together

easily. The Damper Control Module is approved for indoor use only and should

never be installed with any of its components exposed to the elements. The Damper

Control Module (and zone dampers) may be installed in any area where the

temperature remains between --4_F to 158_F(--20_Cto70_C), and there is no

condensation. The cover must be installed to prevent damage from other sources.

Do not locate where it will be accessible to children. It may be mounted in either

vertical or horizontal position. Remember that wiring access is likely the most

important consideration.

PERSONAL INJURY HAZARD

Failure to follow this caution may result in personal injury.

To prevent possible damage to the Damper Control Module,

DO NOT mount on plenum, ductwork, or flush against

furnace or fan coil.

CAUTION

4.5. Mounting

First become familiar with all plastic assembly pieces shown on the following page.

The Evolution Connex Control will snap together with the backplate. A backplate is

supplied. Attach backplate using only a small hole in the wall allowing a four wire

connection to pass through. Mount the assembly to the backplate.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 99 100

No comments

Bryant SYSTXBBECW01 Instruction Manual Page 23